EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 41
Even if the combination of staple desi
nated staple position is valid, and the 180 de
rees
rotation is performed throu
hout the copy.
For staplin
paper other than A4 and A3 at Rear (at the rear of the
compile tray), the staple is run parallel to the paper ed
le is as follows:
Front (at the front of the compile tray) : 45 de
rees
Double (double-staplin
at the center of the compile tray)
: parallel
Rear (at the rear of the compile tray) A4, A3:: 45 de
rees
: parallel
If Reset is performed while compile tray holds paper, the job is
terminated and paper is ejected without staplin
may not be carried out if Print overrun error occurs.
SETUP MENU
Setup Menu/Auto Eject Pa
e
Whether or not paper is ejected when a receive time-out occurs.
On: Paper is ejected with a time-out. Staplin
is performed with
staple desi
nation.
Off:Paper is not ejected with a time-out.
SUPPORT MENU
This settin
menu appears only when the printer is brou
ht into Support
mode by special operation at power-on, and can then be selected. By
turnin
off the power and restartin
after that, the Support Menu is
deleted from the menu and the printer is brou
ht into usual mode. The
support mode is a mode for users to set and execute the items which
are not usually set (HDD initialization etc.).
Support Menu/HDD Format
Press the settin
execution switch, and HDD initialization
(formattin
) will start. Reboot (warm-boot) after initialization is
finished. After rebootin
, the support mode is cleared (returnin
to
usual mode).
Support Menu/Adobe PS 3 kit HDD Init
Press the settin
execution switch, and PS area initialization (no
formattin
) will start. Reboot (warm-boot) after initialization is
finished. After rebootin
, the support mode is cleared (returnin
to
usual mode).
MAINTENANCE MENU
En
ine Status Sheet (Maintenance Menu)
The en
ine status sheet is printed. Before performin
this operation,
be sure to place the printer in a normal mode (a mode other than
maintenance mode), check that there is no service call related to the
en
ain, and enter the maintenance mode.
The maintenance menu functions from En
ine Status Sheet to Error
Lo
Clear are not open to users.
Total Counter Clear (Maintenance Menu)*
1*2
Execute this operation to clear Total Counts on the en
ine board to
zero. Total Counts are printed on the en
ine status sheet.
NOTE:Page Count in the Setup Menu is counted on the controller
side (main board), and the value of the Page Count is
different from Total Counts on the engine board.
To Next Page
Loading...
