C-3
Hardware & Software Training
FARO’s training program is designed to instruct trainees in the
operation of FARO’s hardware and software, which the customer has
purchased. The training classes are set up for each trainee to obtain
valuable hands on application exposure. This will help the trainees in
their everyday use of the hardware and software. FARO also feels that
once the trainee completes the training, finding solutions to problems or
applying applications will be simpler. Details are as follows:
1 The training class will prepare attendees to successfully attain an
operators certification (see Certification Requirements section for
more details).
2 The fee schedules for advanced additional training courses can be
obtained from Customer Service, or the Sales department.
Certification Requirements
The Edge operator’s inherent ability to understand 3D concepts may be
in their background training. However, the precision with which the
operator performs 3D measurements with the Edge is critical in
establishing the accuracy and repeatability of the results of subsequent
measurements.
In order to establish the proficiency of Edge operators, FARO has
instituted an Operator Certification program, where each operator’s
knowledge and understanding of the Edge is evaluated. The successful
operator is awarded a certificate which identifies him/her as an
accredited Edge operator. The requirements are as follows:
1 Attend a FARO-conducted basic training course, either at a FARO
Facility or on site at your facility.
2 Certification will be awarded once the class has been completed, and
then the certified user will be registered for hardware and software
support.
To certify an operator, call FARO’s Training Department, 800.736.0234
(North America), +1 407.333.9911 (Worldwide), for updated
information.
08M52E00_FaroArm_Edge.book Page 3 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
