Ranger HRC™ operator´s manual – Joystick Control Unit
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008 35
JCU joystick and keypad – NORMAL mode
Feature ORIGINAL setting ALTERNATIVE setting
Joystick Move the joystick to the left/right to pan the system left/right.
Move the joystick forwards/backwards to tilt the system up/down.
NOTE: The default tilt behavior (above) can be inverted in the Setup
-Pan/Tilt dialog box, see section 7.6.1.3.
Joystick collar Turn the joystick collar to the
left/right to focus near/far.
Turn the joystick collar to the left/right
to zoom out/in.
Press the
FCN button and turn the
joystick collar to the left/right to focus
near/far.
Joystick button
Press the joystick button < 1 second
to go to the next eld-of-view.
Press the joystick button > 1
second
toggle between Slave mode
on/off, see section 7.5.1.
Press the joystick button < 1
second
to perform a one-shot auto focus
adjustment.
Press the joystick button > 1
second
to
toggle between Slave mode on/off, see
section 7.5.1.
FCN
Button FCN is used together with other buttons to provide additional functionality.
SCN Press the SCN button to enter AUTOSCAN mode. If there are no autoscan
points, there will be no action.
ID Reserved for future capabilities.
TV/IR Press the TV/IR button to toggle between TV imaging and IR imaging.
INV Press the INV button to toggle between White hot and Black hot IR palette.
Press the
FCN + INV buttons to activate the LRF unit and enter LRF mode.
C Button C is used together with other buttons to provide additional functionality.
NUC Press the NUC button < 1
second
to perform an Internal NUC.
Press the
NUC button > 1
second
to perform a one-shot auto focus adjustment.
Press the
FCN + NUC buttons < 1
second
to perform an External NUC against
the lens cover.
Press the
FCN + NUC buttons > 1
second
to go to the xed focus position.
Press the
C + NUC buttons < 1
second
to perform an External NUC against the
scene.
Press the
C + NUC buttons > 1
second
to perform a one-shot auto focus
adjustment.
NOTE: The default behavior (above) of the NUC, FCN + NUC and C + NUC
buttons can be inverted in the
Setup-Image dialog box, see section 7.6.1.1.
To Next Page
Loading...
