JCU joystick and keypad – NORMAL mode
Feature ORIGINAL setting ALTERNATIVE setting
PRK
Press the PRK button < 1
second
to send the system to the home position. If the
PRK button is pressed < 1
second
again when the system is in home position,
the lens cover of the IR Camera will be closed and PARK mode will be entered,
see section 5.1.3.
Press the PRK button > 1
second
to send the system to the mechanical home
position, close the lens cover of the IR Camera and enter PARK mode, see
section 5.1.3.
NOTE: At system start up, the PRK button has to be pressed for more
than 3 seconds to activate the Pan/Tilt unit.
Press the button to zoom in.
Press the
button to zoom out.
When the adjustment mode is set to
DDE (linear or full), see section 11.3.2:
Press and hold down the button to
increase the DDE value.
Press and hold down the
button to
decrease the DDE value.
If the adjustment mode is set to AUTO
(linear of full) or MANUAL, the
and
buttons have no function.
Press and hold down the
FCN +
buttons to increase the level value.
Press and hold down the
FCN +
buttons to decrease the level value.
NOTE: When the level value is changed, the system enters the Manual
adjustment mode, see section 11.3.2.
Press the C + buttons to manually open the lens cover.
Press the
C +
buttons to manually close the lens cover.
Press the button to go to previous active autoscan point position.
Press the
button to go to next active autoscan point position.
If there are no autoscan points, there will be no action.
NOTE: This function of the buttons can be disabled, see section 7.6.1.3.
Press and hold down the FCN + buttons to decrease the span value.
Press and hold down the
FCN +
buttons to increase the span value.
NOTE: When the span value is changed, the system enters the Manual
adjustment mode, see section 11.3.2.
FRZ Press the FRZ button to freeze/unfreeze the image.
ENTER
Press the ENTER button to enter MENU mode.
To Next Page
Loading...
