7.6.1.2.1 Setup – GUI Size dialog box
The Setup – GUI size dialog box is used to select GUI size.
The crosshair reticle, the FOV brackets and the autoscan point indicators
are not affected by the change of GUI size.
Figure 7.20 Setup – GUI size dialog box.
Setup – GUI Size dialog box
Feature Description
Preset mode The Preset mode feature is used to select GUI size mode.
• Full: The full area is used to display the system software graphics. This
setting keeps as much as possible of the video image free from overlaid
information. However, many monitors cut the video image close to the
edges. With such a monitor, some of the graphics may not be visible with
this setting.
• Compressed: The edges of the area where the system software graphics
is displayed are adjusted to allow all graphics to be visible. This is a xed
setting that ts most monitors.
• Custom: Enables manual settings of Left, Top, Right and Bottom edges.
Left/Top/Right/
Bottom edge
The Left/Top/Right/Bottom edge items are used to adjust the edges of the
area where the system software graphics is displayed. The edges can only
be adjusted when Custom is selected.
To Next Page
Loading...
