Torque control (Mode selection)
Related functions: d32, d33 (Speed limits / Over speed level 1 and 2)
d35 (Over speed detection level)
When vector control with speed sensor is selected, the inverter can control the motor-generating torque according
to a torque command sent from external sources.
Figure 5.3-11 Block Diagram of Torque Control
■ Torque control (Mode selection) (H18)
H18 specifies whether to enable or disable the torque control. Enabling the torque control offers two choices: with
torque current command and with torque command.
Data for H18 Available control
0 Disable (Speed control)
2 Enable (Torque control with torque current command)
3 Enable (Torque control with torque command)
To Next Page
Loading...
