FUNCTION CODES
Chap 5
■ Specific function codes
The following function codes can take values on memory by using the customizable logic “Function code switch
(6003)”. Overwritten values are cleared with power off.
Code Name Code Name
F07 Acceleration time 1 H66 Non-linear V/f 3 (Voltage)
F08 Deceleration time 1 H91 PID feedback wire break detection
F15 Frequency limiter (Upper) J03 PID control P (Gain)
F16 Frequency limiter (Lower) J04 PID control I (Integral time)
F21 DC braking 1 (Braking level) J05 PID control D (Differential time)
F22 DC braking 1 (Braking time) J06 PID control (Feedback filter)
F23 Starting frequency 1 J10 PID control (Anti-reset windup)
F24 Starting frequency 1 (Holding time) J12 PID control (Upper limit of warning (AH))
F25 Stop frequency J13 PID control (Lower limit of warning (AL))
F39 Stop frequency (Holding time) J15 PID control (Sleep frequency)
F40 Torque limiter 1 (Driving) J16 PID control (Sleep timer)
F41 Torque limiter 1 (Braking) J17 PID control (Wakeup frequency)
F44 Current limiter (Level) J18 PID control (Upper limit of PID process output)
E10 Acceleration time 2 J19 PID control (Lower limit of PID process output)
E11 Deceleration time 2 J58 PID control
(Detection width of dancer position error)
E12 Acceleration time 3 J59 PID control P (Gain) 2
E13 Deceleration time 3 J60 PID control I (Integral time) 2
E14 Acceleration time 4 J61 PID control D (Differential time) 2
E15 Deceleration time 4 J62 PID control block selection
C05 Multistep frequency 1 J68 Brake control signal (Brake-release current)
C06 Multistep frequency 2 J69 Brake control signal
(Brake-release frequency/speed)
C07 Multistep frequency 3 J70 Brake control signal (Brake-release timer)
C08 Multistep frequency 4 J71 Brake control signal
(Brake-apply frequency/speed)
C09 Multistep frequency 5 J72 Brake control signal (Brake-apply timer)
H28 Droop control J95 Brake control signal (Brake-release torque)
H50 Non-linear V/f 1 (Frequency) J97 Servo lock (Gain)
H51 Non-linear V/f 1 (Voltage) d01 Speed control 1 (Speed command filter)
H52 Non-linear V/f 2 (Frequency) d02 Speed control 1 (Speed detection filter)
H53 Non-linear V/f 2 (Voltage) d03 Speed control 1 (P (Gain))
H57 1st S-curve acceleration range (At starting) d04 Speed control 1(I (Integral time))
H58 2nd S-curve acceleration range (At arrival) d05 Speed control 1 ( FF (Gain))
H59 1st S-curve deceleration range (At starting) d07 Speed control 1
(Notch filter resonance frequency)
H60 2nd S-curve deceleration range (At arrival) d08 Speed control 1 (Notch filter attenuation level)
H65 Non-linear V/f 3 (Frequency)
To Next Page
Loading...
