Fuji Electric FRENIC-Ace series - Page 768

Appendix G Conformity with Standards
Appendix-28
Power supply voltage Inverter type Specification Filter type
Three-phase 200V
FRN0001E2
■
-2

HND/HHD
W62400−T1688−E002
FRN0002E2■-2 HND/HHD W62400−T1688−E002
FRN0004E2
■
-2

HND/HHD
W62400−T1688−E002
FRN0006E2■-2 HND/HHD W62400−T1688−E002
FRN0010E2■-2 HND/HHD W62400−T1688−H005 *3)
FRN0012E2■-2 ND/HHD W62400−T1688−H005 *3)
FRN0020E2
■
-2

ND/HHD
W62400−T1688−H005 *3)
FRN0030E2■-2
HND FS5956-53-52
HHD
FS5956-53-52
FRN0040E2■-2
HND EFL-15SP-2
HHD FS5956-53-52
FRN0056E2■-2
HND EFL-15SP-2
HHD
EFL-15SP-2
FRN0069E2■-2
HND EFL-15SP-2
HHD
EFL-15SP-2
FRN0088E2■-2
HND EFL-22SP-2
HHD EFL-22SP-2
FRN0115E2■-2
HND FS5536-180-40
HHD
EFL-22SP-2
Single-phase 200V
FRN0001E2■-7 HHD W62400-T1775-E001
FRN0002E2
■
-7

HHD
W62400-T1775-E001
FRN0003E2■-7 HHD W62400-T1775-E001
FRN0005E2■-7 HHD W62400-T1775-E001
FRN0008E2■-7 HHD W62400-T1775-F001
FRN0011E2
■
-7

HHD
W62400-T1775-F001
*3) A ferrite core is added for input power wires and grounding wire (1 turn).
Note: A box (■) in the above table replaces S (Basic type) or E (EMC filter built-in type) depending on the
enclosure.
A box () in the above table replaces GA, GB or C depending on the model.