Common Service Settings
125
Tools
5
• The print-disabled condition is cancelled when you operate using the control panel after the
ending time.
• To enable printing during the printer lockout duration, select a job under [Current and
Pending Jobs] on the [Job Status] screen, and then select [Promote Job].
Power Saver/Energy Saver Timers
The machine is provided with the Low Power and Sleep modes as the power saving mode.
When a specified period of time has elapsed, the machine switches to these modes in the
following order to reduce power consumption.
Last operation on the machine J Low Power mode J Sleep mode
For more information, refer to "Energy Saver Mode" (P.19).
Note • There is no setting to disable switching to the Low Power mode or the Sleep mode.
îš„From Last Operation to Low Power Mode
Specify a time period between the last operation and entering the Low Power mode in the
range from 1 to 240 minutes, in 1 minute increments.
îš„From Last Operation to Sleep Mode
Specify a time period between the last operation and entering the Sleep mode from 1 to 240
minutes, in 1 minute increments.
Note • Configure the [From Last Operation to Sleep Mode] time to be longer than the [From Last
Operation to Low Power Mode] time.
Time Zone
Set the time difference from GMT.
Daylight Savings
Select [Adjust Off], [Adjust by Day, Month & Time], or [Adjust by Month, Week, Day of Week
& Time].
If [Adjust by Day, Month & Time] is selected, you can specify and set the month, day, and
time for [Start Date] and [End Date].
If [Adjust by Month, Week, Day of Week & Time] is selected, you can specify and set the
month, week, day of week, and time for [Start Date] and [End Date].
Print-On-Demand Duration (ApeosPort Series Models Only)
Specify the duration for the machine to receive a print job from web applications. Unless the
machine receives full data of the print job within the specified period of time, the machine
does not process the print job.
Specify the duration within the range of 0 to 255 minutes in 1 minute increments. If you
specify [0], it means that no time limitation is set on the machine for receiving data.
Note • When instructing a print job that contains a large amount of data, or when instructing a print
job whose contents take a while to be processed, transmission may be timed out before the
machine receives the last page of the print job. If transmission is timed out, the received data
of the print job is canceled. Consider the machine usage environment when you specify the
duration time.
Audio Tones
Select whether or not to sound an alarm, for example when a job ends or a fault occurs.
Control Panel Select Tone
Select the sound to be made when a button displayed on the screen is correctly selected.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
To Next Page
Loading...
Need help?
General
