7 Printer Environment Settings
270
Printer Environment Settings
7
6
Restart the machine, print a configuration report to confirm that the NetWare port is
enabled, and check the NetWare device name and the network address.
For information on how to print a configuration report, refer to "Print Reports" (P.83).
7
Configure the machine using the CD-ROM of the Driver CD Kit.
Refer to the manual contained in the CD-ROM of the Driver CD Kit for the configuration procedure.
Using a LPD Port in NDPS
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard, and select [Enter].
Note • The default user ID is “11111”. When using the Authentication feature, a passcode may be
required. The default passcode is “x-admin”.
3) Select [Tools].
2
Enable the LPD port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [LPD] and then select [Change Settings].
4) Select [Port Status] and select [Change Settings].
5) Select [Enabled], then select [Save].
6) Select [Close] repeatedly until the [Connectivity & Network Setup] screen is
displayed.
3
Set an IP address and the others.
If an IP address is already set, this step is not necessary. If DHCP or BOOTP is
available in your environment, configure the method for obtaining the addresses. The
configuration of an IP address, a subnet mask, and a gateway address is not required.
For information on how to set an IP address, refer to "Protocol Settings" (P.161).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
6
Select [Reboot Now].
7
Restart the machine, and print a configuration report to confirm that the LPD port is
enabled and TCP/IP is configured.
For information on how to print a configuration report, refer to "Print Reports" (P.83).
Configure other LPD settings as necessary. Refer to "CentreWare Internet Services Setting Items"
(P.271).
8
Configure the machine using the CD-ROM of the Driver CD Kit.
Refer to the manual contained in the CD-ROM of the Driver CD Kit for the configuration procedure.
Step 3 Configuration on the Computer
In order to print from the machine, the computer needs to have a print driver installed.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.260).
For information on the driver installation procedure, refer to the manual contained in the CD-ROM of
the Driver CD Kit.
To Next Page
Loading...
Need help?
General
