Connectivity & Network Setup
165
Tools
5
HTTP Proxy Server Password
Enter a password of the HTTP server. Up to 31 characters are allowed.
HTTPS Proxy Server Name
Enter the HTTPS server name. Up to 255 characters are allowed.
HTTPS Proxy Server Port Number
Set the HTTPS server port number in the range from 1 to 65535.
The default value is 8080.
Important • Do not use the numbers assigned to the other ports.
HTTPS Proxy Server Authentication
Select whether to enable the authentication feature of the HTTPS server.
HTTPS Proxy Server Login Name
Enter a login name of the HTTPS server. Up to 31 characters are allowed.
HTTPS Proxy Server Password
Enter a password of the HTTPS server. Up to 31 characters are allowed.
Outgoing/Incoming E-mail Settings
Set e-mail transmission and reception.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items.
îš„Server Name/IP Address
Enter a server name or IP address. Up to 128 characters are allowed.
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
îš„Port Number
Enter a port number in the range from 1 to 65535 when selecting [Enter Number].
The default value is 110.
Important • Do not use the numbers assigned to the other ports.
îš„Polling Interval
Set the interval for checking the e-mail on the POP3 server in the range from 1 to 120
minutes, in 1 minute increments.
îš„Login Name
Enter the name to login to the POP3 server. Up to 64 single-byte characters are allowed.
îš„Password
Enter a password of the POP3 server. Up to 64 single-byte characters are allowed.
Using the numeric keypad displayed by pressing [Change Settings], enter the same
password in [New Password] and [Retype Password]. If you do not set the password, leave
the text boxes blank and select [Save].
îš„POP Password Encryption
Select [On (APOP)] to encrypt the password.
Note • When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
To Next Page
Loading...
Need help?
General
