Scan Service Settings
181
Tools
5
Scan Service Settings
Make settings relating to the scanner feature.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• When [Fax Server] is selected in the System Settings, [Scan Service Settings] is replaced
with [Scan/Fax Service Settings].
For information on scanner environment settings, refer to "Scanner Environment Settings" (P.287).
The following shows the reference section for each item.
First Tab ................................................................................................................................... 181
Scan Defaults............................................................................................................................ 181
Scan to PC Defaults.................................................................................................................. 184
Original Size Defaults .............................................................................................................. 184
Output Size Defaults ................................................................................................................ 185
Reduce/Enlarge Presets............................................................................................................ 185
Other Settings........................................................................................................................... 185
1
On the [Tools] screen, select [System Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.104).
2
Select [Scan Service Settings].
3
Select the item to be set or changed.
First Tab
You can set items relating to the First ([E-mail]/[Scan to Mailbox]/[Network Scanning]/
[Scan to PC]) screen display.
Feature in 2nd Column
You can set the features that appear in the second column of the First ([E-mail]/[Scan to
Mailbox]/
[Network Scanning]/[Scan to PC]) screen.
You can select from [2 Sided Scanning], [Resolution], [Lighten/Darken], and [Reduce/
Enlarge].
Reduce/Enlarge - Buttons 2, 3
This item can be set when [Reduce/Enlarge] is selected in [Feature in 2nd Column].
Select the magnification from the registered R/E Preset buttons.
For information about R/E Preset buttons, refer to "Reduce/Enlarge Presets" (P.185).
Scan Defaults
Set the default values for the scanner feature. When the power is turned on or the
machine returns from a Power Save mode, or when the <Clear All> button is pressed,
the system returns to the defaults set here. By setting features you often use as
defaults, you can avoid extra operations required in use.
The values set become valid after the power has been turned off and on again.
To Next Page
Loading...
Need help?
General
