3 Maintenance
64
Maintenance
3
Replacing the Staple Cartridge (for Finisher-C1 with Booklet Maker)
When the Finisher-C1 with Booklet Maker (optional) is installed and it is time to replace
the staple cartridge, a message appears on the touch screen. When this message
appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the front cover of the finisher.
2
While pressing Lever R2 and Lever R3 to the
right (1), pull the staple cartridge unit out of
the machine (2).
3
Hold the tabs on both sides of the staple
cartridge.
4
While holding the tabs of the staple
cartridge, rotate it in the direction of the
arrow shown in the figure.
R2
R3
To Next Page
Loading...
Need help?
General
