5 Tools
194
Tools
5
Preset %
You can select from preset ratios.
Variable %
You can specify a magnification from 50 to 400% in 1% increments.
Original Size Defaults
You can set the original size shown in [Original Size] in the [Layout Adjustment] screen.
An original size is assigned to each of the 17 buttons other than [Auto Size Detect].
When frequently scanning non-standard size originals, by presetting the non-standard
size, you can save time to enter the original size each time a document is scanned.
A/B Series Size
Select from 10 sizes of A and B series.
Inch Size
Select from 11 sizes of inch series.
Others
Select from other 14 sizes.
Local Terminal Information
You can set the local terminal information, including a local name and sender name.
For information about how to enter characters, refer to "Entering Text" (P.27).
Note • The displayed items may be different, depending on the options installed.
• There are a maximum of three lines that can be used for G3 communications: line 1, line 2,
and line 4.
• For each line, you can set a G3 ID (fax number), G3 dialing type, and G3 line type.
• In accordance with the lines added, either line 2 or line 4, or both lines information can be
specified.
Local Name
Register the name of the local terminal as the local name.
The local name is shown in the recipient's [Activity Report]. However, depending on the
recipient's device, it may not be shown.
Enter up to 20 characters using the keyboard displayed or the numeric keypad.
Company Logo
Register the sender name (company logo). Enter up to 30 characters using the keyboard
displayed or the numeric keypad. The sender name is printed in the Transmission Header
Text or Cover Page.
Machine Password
Set the machine password when you want to limit the other parties that can send faxes.
When the machine password is set, only a party that sends the correct machine password by
F code is allowed to send or poll. Note that this means that faxes cannot be accepted from a
fax without the F code feature.
G3 Line - Fax ID
When using G3 communications, register the G3 ID. The G3 ID is normally set to the local
terminal fax number.
Using the displayed keyboard and the numeric keypad, specify with not more than 20 digits.