Replacing Consumables
59
Maintenance
3
Replacing the Staple Cartridge (for Finisher-A1)
When the Finisher-A1 (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When this message appears, load a new
staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the front cover of the finisher.
2
Take the staple cartridge out of the finisher.
3
After removing the staple cartridge, check
the inside of the finisher for any remaining
staples.
4
Pinch both sides of the empty staple case
with your fingers (1), and remove the staple
case from the cartridge (2).
1
1
2
To Next Page
Loading...
Need help?
General
