5 Tools
126
Tools
5
Control Panel Alert Tone
Select the sound to be made when a button that cannot be selected is selected, or an error
occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Base Tone
For a button that toggles (changes setting each time it is pressed), set the sound to be made
when in the home position. The machine makes this sound when it exits the Interrupt mode.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Machine Ready Tone
Set the sound for when the machine is ready to copy or print, after powering on, for example.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Job Complete Tone 1, 2
Select the sound to be made when a job is completed normally.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
You can select the target jobs.
Fault Tone
Select the sound to be made when an error termination occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Auto Clear Alert Tone
Select the sound to be made at 5 seconds before automatically returning to the initial screen,
when the auto clear feature is enabled.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Alert Tone
Select the sound to be made when a fault such as a paper jam occurs, and the fault is left
unattended to.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Out of Paper Warning Tone
Select the sound to be made when a job is suspended due to running out of paper in a tray.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Low Toner Alert Tone
Select the sound to be made when the toner cartridge needs to be replaced.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Stored Programming Tone
Select the sound to be made while a stored program is registered.
You can select the volume from [Soft], [Normal], and [Loud].
It is not possible to disable this sound.
To Next Page
Loading...
Need help?
General
