9 Scanner Environment Settings
296
Scanner Environment Settings
9
Configuration of Job Flow Sheets
This section describes how to configure the machine to use the Job Flow Sheets
service.
The following shows the reference section for each item.
Step 1 Enabling Ports and Setting TCP/IP................................................................................296
Step 2 Configuring the SNMP Port...........................................................................................297
Step 3 Configuration on the Computer .....................................................................................297
Step 1 Enabling Ports and Setting TCP/IP
In order to use the Job Flow Sheets service, enable the SOAP, SNMP, and Internet
Services (HTTP) ports, and then set an IP address and the other addresses. The
procedure for setting the machine is as follows.
Note • The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.249).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools].
2
Enable the SOAP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SOAP] and then select [Change Settings].
4) Select [Port Status] and select [Change Settings].
5) Select [Enabled] and then select [Save].
6) Select [Close] repeatedly until the [Port Settings] screen is displayed.
3
Enable the SNMP port.
1) Select [SNMP] and then select [Change Settings].
2) Select [Port Status] and select [Change Settings].
3) Select [Enabled], then select [Save].
4) Select [Close] repeatedly until the [Port Settings] screen is displayed.
5) Enable the Internet Services (HTTP) port as above.
6) Select [Close] repeatedly until the [Tools] screen is displayed.
4
Set an IP address and the others.
If an IP address is already set, this step is not necessary. If DHCP or BOOTP is
available in your environment, configure the method for obtaining the addresses. If an
IP address cannot be obtained automatically, or if manual configuration is preferred,
manually enter an IP address, subnet mask, and gateway address.
To Next Page
Loading...
Need help?
General
