Fuji Xerox ApeosPort-III C2201

Installation When Using NetWare
269
Printer Environment Settings
7
Installation When Using NetWare
This section describes how to install the machine by using Netware.
The following shows the reference section for each item.
Step 1 Preparations................................................................................................................... 269
Step 2 Configuration on the Machine ...................................................................................... 269
Step 3 Configuration on the Computer .................................................................................... 270
CentreWare Internet Services Setting Items ............................................................................ 271
Step 1 Preparations
Prepare the following items to install the machine when using a NetWare network.
z
NetWare server
z
TCP/IP or IPX/SPX network environment
z
CD-ROM of the Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedure to connect the machine to a
NetWare network.
Note • The configuration can also be performed using CentreWare Internet Services or IP Address
Setting Tool included in the CD-ROM of the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.271).
Using IPX/SPX
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools].
2 Enable the NetWare port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [NetWare], and select [Change Settings].
4) Select [Port Status], and select [Change Settings].
5) Select [Enabled], then select [Save].
3 Select [Close] repeatedly until the [Tools] screen is displayed.
4 Select [Close].
5 Select [Reboot Now].