Notes and Restrictions
557
Appendix
15
computer will be printed out in order before any later instructions when the machine
is powered back on.
While Printing
z
When [lpd (Spool)] is set to either [Hard Disk] or [Memory]
If the transmitted print data size exceeded the available amount of either hard disk
or memory, the print data will not be received.
Note • When the print data has exceeded the receivable size, some computers may immediately
re-transmit the print data. When this occurs, the computer appears to be halted. Deal with
this problem by canceling the print data transmission from the computer.
z
When [lpd (Spool)] is set to [Off]
While the machine is receiving a print request from a computer, the machine cannot
accept any print requests from other computers.
z
When a computer's IP address or a computer name is changed
When a computer's IP address or a computer name is changed, query processing
and cancel processing from the machine will not be performed correctly. Switch the
machine off and on when there is no print data in the receiving buffer.
Note • Canceling print jobs or forcing the machine to print the remaining jobs in the receiving buffer
can be operated from the control panel on the machine. For information on the operation,
refer to "11 Job Status" in the User Guide.
Notes and Restrictions for Using EtherTalk
The following are the notes and restrictions for using EtherTalk.
Printer Name
Printer names used to be identified by clients are set not to duplicate each other. When
assigning a new printer name, if the same printer name has already existed on the
network, the system automatically change the printer name on startup.
<Rules for changing printer name>
Printer names are changed according to the following rules:
z
Names of 31 characters or less
Add a number to the end of the printer name. If the same printer name with the
number added has still existed on the network, increase the added number by 1.
z
Names of 32 characters
Change the last character of the printer name to a number. If the same printer name
with the last character changed has still existed on the network, increase the
changed number by 1.
If the printer name has been changed, when browsing [Protocol Settings] on the
[Properties] tab of CentreWare Internet Services, the previous printer name set
before the change is displayed. However, the changed printer name is registered on
the network, clients can browse the printer using the changed printer name. If the
printer is turned off and then on while the printer name has been changed, the printer
is activated with the changed printer name. If the same printer name has already
existed on the network, the printer name will be changed according to the rules
described above on startup.
Assign a printer name not to duplicate to other printer names on the network.
To Next Page
Loading...
Need help?
General
