Copy Service Settings
153
Tools
5
Page Numbers - Style
Set the default value for [Style] displayed when [Page Numbers] is selected for [Annotation]
on the [Output Format] screen.
Page Numbers - Position on Side 1, 2
Set the default value for [Position] displayed when [Page Numbers] is selected for
[Annotation] in the [Output Format] screen.
Page Numbers - Font Size
Set the default value for [Font Size] displayed when [Page Numbers] is selected for
[Annotation] in the [Output Format] screen.
Bates Stamp - Number of Digits
Set the default value for [Number of Digits] displayed when [Bates Stamp] is selected for
[Annotation] in the [Output Format] screen.
Bates Stamp - Position on Side 1, 2
Set the default value for [Position] displayed when [Bates Stamp] is selected for [Annotation]
in the [Output Format] screen.
Bates Stamp - Font Size
Set the default value for [Font Size] displayed when [Bates Stamp] is selected for [Annotation]
in the [Output Format] screen.
Booklet Creation - Cover Tray
Set the default value for [Covers Tray] in the [Booklet Creation] screen.
Covers - Front Cover Tray, Back Cover Tray
Set the default value for [Front Cover Tray] and [Back Cover Tray] in the [Covers] screen.
Insert Separators - Separator Tray
Set the default value for [Separators] in the [Segment Separators] screen.
Copy Control
These settings relate to copy operation control.
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears asking
how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the subsequent
processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto
Job Release" (P.124).
Delete Job
The stored data is discarded.
Run Job
The read-in data is treated as valid, and the part of the original read in is copied.