5 Tools
168
Tools
5
îš„Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
îš„Primary Server Port Number
Set the Primary server port number in the range from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
îš„Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value in
the range of 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
îš„Secondary Server Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.
îš„Authentication Method
Select the method for LDAP authentication from [Direct Authentication] and [Authentication of
User Attributes].
z
Direct Authentication
User ID and password entered by user are used for LDAP authentication.
z
Authentication of User Attributes
The entered User ID is used as an attribute value specified in [Attribute of Types User Name]
for a search on a LDAP server. [Attribute of Login User Name] of a user that is found through
the search is used for LDAP authentication.
îš„Attribute of Typed User Name
When [Authentication of User Attributes] is used for LDAP authentication, set an attribute of
User ID entered by user. Up to 32 characters are allowed.
Set the attribute of the LDAP server that corresponds to the value to be entered as the user
name from the control panel. For example, when you want the mail address to be entered, set
"Mail."
îš„Attribute of Login User Name
When [Authentication of User Attributes] is used for LDAP authentication, set an attribute of
user ID entered by user. Up to 32 characters are allowed.
îš„Use Added Text String
Select whether to use additional text strings for the user ID.
îš„Text String Added to User Name
Enter text strings for [Text String Added to User Name]. You can use up to 64 characters.
When [Use Added Text String] is set to [Enabled], enter the corresponding fixed text string.
Example:
When "mail" is set for [Attribute of Typed User Name] and the information registered for that
target user was "mail@myhost.example.com," normally "mail@myhost.example.com" needs
to be entered.
However, if [Use Added Text String] was set to [Enabled] and "@myhost.example.com" was
specified for [Text String Added to User Name], input is simplified because the only data that
needs to be entered from the control panel is "mail" as the machine adds
"@myhost.example.com" to the end.
To Next Page
Loading...
Need help?
General
