Connectivity & Network Setup
171
Tools
5
îš„Device Certificate - Server
You can select a certificate to be linked.
îš„HTTP - SSL/TLS Communication
Enables or disables the HTTP SSL/TLS communications.
îš„HTTP - SSL/TLS Port Number
Specifies the port number used for HTTP SSL/TLS communication within the range from 1 to
65535.
The default value is 443.
Important • Do not use the numbers assigned to the other ports.
îš„LDAP - SSL/TLS Communication
Enables or disables the LDAP SSL/TLS communications for LDAP authentication and
address book search by LDAP.
The port number of [Primary Server Port Number] and [Secondary Server Port Number] for
LDAP server must be changed, if [LDAP - SSL/TLS Communication] is enabled.
The port number for SSL/TLS communications with LDAP directory server is normally 389.
îš„Device Certificate - Client
Select a certificate to be linked.
îš„Verify Remote Server Certificate
When the machine is to be operated as an SSL client, select whether to enable or disable a
certificate of a remote server.
S/MIME Settings (ApeosPort Series Models Only)
Configure the settings of S/MIME.
îš„Device Certificate - S/MIME
Select a certificate to be linked.
For information on the certificate, refer to "Encryption and Digital Signature Settings" (P.313).
îš„S/MIME Communication
Select whether to enable or disable the S/MIME communication.
îš„Receive Untrusted E-mail
If you select [No], the machine does not receive the following e-mail:
z
E-mail other than e-mail sent by S/MIME when [S/MIME Communication] is activated.
z
E-mail that fails to attach a signature or verification.
z
E-mail that is attached with an expired certificate.
îš„Message Digest Algorithm
Select a message digest algorithm. Two algorithms are available: SHA1 and MD5.
îš„Message Encryption Method
Set the encryption method for mail contents. Four methods are available: 3DES, RC2-40,
RC2-64, and RC2-128.
îš„Digital Signature - Outgoing E-mail
Select whether or not to always add a digital signature to e-mail. You can also select the
setting in which the machine asks to add a digital signature to the e-mail whenever you send.
îš„Signing Certificate for E-mail Attachment
Set the certificate to be used for attaching a signature to e-mails.
îš„Certificate Auto Store
Select whether or not to automatically store a S/MIME certificate attached with the e-mail
when receiving e-mail sent from an address registered in the address book.
îš„Digital Signature - Outgoing Internet Fax
Set the certificate to be used for sending Internet faxes.
To Next Page
Loading...
Need help?
General
