13 Authentication and Account Administration
352
Authentication and Account Administration
13
2
Using the numeric keypad or the keyboard displayed, enter the system administrator’s
user ID to enter the System Administration mode, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3
Select [Tools].
4
Select [Authentication/Security Settings].
5
Select [Authentication].
6
Select [Create Authorization Groups].
7
Select "(No Name)" and select [Create/Delete].
8
Enter a group name into [Group Name].
9
Set [Restrict Recipient Selection Method], [Restrict User to Edit Address Book], [Allow
User to Disable Active Settings], and [When Protection Code Is Detected].
Refer to "Create Authorization Groups" (P.238).
10
Select [Close].
To Next Page
Loading...
