Network-related Problems
385
Problem Solving
14
The number of print queues
set for the machine exceeds
the maximum number of
supported queues on the
machine.
Use NWADMIN from a
computer to check the
machine's [Assignment] print
queue list to see if the
desirable print queue is
assigned to the machine.*
Re-transmit the print data to
the print queue which is
assigned to the machine.*
The slave file server is not
configured. ([Bindery
Service] mode)
Use PCONSOLE from a
computer to confirm if the
slave file server is registered
to [Service NetWare Server]
on the print server indicated
by [Print Server
Information].*
Use PCONSOLE from a
computer to register the
slave file server and
propagate the configuration
parameters.
Printer types do not match. Use PCONSOLE from a
computer to confirm if the
printer type is set to parallel,
port is set to LPT1 and
location is set to automatic
mode (local) under [Print
Server Information] >
[Printer] > [Printer xxx
Environment Configuration].*
Use PCONSOLE from a
computer to set the printer
type to parallel, port to LPT1,
location to automatic mode
(local) and propagate the
configuration parameters.*
The slave file server
configuration is mismatched.
([Bindery Service] mode)
Use PCONSOLE from a
computer to confirm if the
printer type is set to [Defined
Elsewhere] under [Print
Server Information] >
[Printer] > [Printer xxx
Environment Settings].*
If not set to [Defined
Elsewhere], change to
[Defined Elsewhere] and
propagate the configuration
parameter.*
The form number on the print
data and the form number
set to the printer do not
match.
Use NWADMIN on a
computer to select the
machine and confirm that the
start number of the form in
the environment setting
matches the number in the
print data.*
Use NWADMIN from a
computer to match the [Start
Form] number in the
machine's environment
setting to the number in the
print data.*
The level settings for the IPX
checksum do not match.
Use the set command from
the console screen on the
file server and confirm
whether the IPX checksum is
set to level 2.
Enter the following command
from the console screen on
the file server to set the IPX
checksum to either level 0 or
level 1.
set Enable IPX Checksum=x
(x = 0 or 1)
The level settings for the
NCP packet signature do not
match.
Use the set command from
the console screen on the
file server and confirm
whether the NCP packet
signature is set to level 3.
Enter the following command
from the console screen on
the file server to set the NCP
packet signature to either
level 0, 1, or 2, and restart
the file server. set NCP
Packet Signature Option=x
(x = 0, 1, or 2)
Cause Check point Remedy
To Next Page
Loading...
Need help?
General
