FUTABA T12K

185
<Functions of Model Menu (Helicopter Functions)>
●Diplay mode selection
*When [rpm] mode is selected above setting, the display
mode can be selected.
* There is no change in the transmitter output even when the
"MODE" is changed. Calibration should be performed via
the governor.
* In order to use the Governor function of the T12K, it is
necessary to change the settings on the governor for the low
side 700rpm mode.
WhentheMODEoftheGovernorscreen's
modelmenuischanged,thechangeisalso
indicatedon-screen.
The chart below indicates the mode percentage and
the corresponding RPM.
MODE 0％ 50％ 100％ 110％
1000-2000rpm 1000rpm 1500rpm 2000rpm 2100rpm
1000-2500rpm 1000rpm 1500rpm 2500rpm 2700rpm
1000-3500rpm 1000rpm 1500rpm 3500rpm 3900rpm
700-2000rpm 700rpm 1500rpm 2000rpm 2100rpm
700-2500rpm 700rpm 1500rpm 2500rpm 2700rpm
700-3500rpm 700rpm 1500rpm 3500rpm 3900rpm
●Fine tuning VR settings
 Movethecursortothe[--]itemandpushthe
RTNbuttontoaccesstheselectionscreen.
Selectthecontrol.
*For a description of the switch selection method, see the
description at the back of this manual.
 Movethecursortotherateitemandpush
theRTNbuttontoswitchtothedatainput
mode.
 AdjustthetrimratebyscrollingthePushdial.
 Initialvalue:0%(0rpm)
 Adjustmentrange:-20~+20%(-200~+200rpm)
*When the RTN button is pushed for one second, the
sensitivity is reset to the initial value.)
 PushtheRTNbuttontoreturntothecursor
mode.
<EXAMPLE>RPM rate is changed with a
switch (SF) irrespective of condition.
Generally,RPMrateisinterlockedwitha
conditionandchangesarate.
Howtochangetworatesinthesame
condition.
1.Select[GOVERNOR]attheModelmenu
andaccessthesetupscreenshownbelow
bypushingtheRTNbutton.
2.Movethecursortothe[COND]itemand
pushtheRTNbuttontoaccesstheselection
screen.Selectthe[SW].PushtheRTNbutton
toreturntothecursormode.And[INH]is
setto[ACT].
3.#numbershowsthepresentswitchstate.
Inthestateof#1,acursorismovedto[--]
andRTNispushed.
4.[SF]ischosenby[H/WSELECT]andthena
topisturnedON.
5.[MODE]and[RATE]ofastateof"#1=SF
top"aresetup.
6.Itisasetupof"#2".Movethecursorto
the[#1]itemandpushtheRTNbuttonto
accesstheselectionscreen.Selectthe[#2].
PushtheRTNbuttontoreturntothecursor
mode.And[INH]issetto[ACT].
SF : Top = #1
●
Thenumber
ofaSWstate