FUTABA T12K

186
<Functions of Model Menu (Helicopter Functions)>
7.Movethecursortothe[--]itemandpush
theRTNbutton.
8.[SF]ischosenby[H/WSELECT]andthena
bottomisturnedONbypushingtheRTN
button.
9.[MODE]and[RATE]ofastateof"#2=SF
bottom"aresetup.
*If the 3 position switch is chosen, 3 rate changes can be
performed.
*Combined use of two or more switches cannot be performed.

SF : Bottom = #2
●
Thenumber
ofaSWstate
●CAL (Calibration)
Thisfunctiontransmitsareferencesignalfrom
thetransmitterforsettingthegovernor'sside
speeddisplay.Thegovernorandtransmitter
setvalues(speeddisplay)canbematched.
*The CAL button can only be displayed in rpm mode.
Button added to the reference signal output screen.
(Displayed only in the rpm mode.)
In "ON", "CAL" appears
1.MovethecursortotheCALbuttonand
pushtheRTNbutton.
2.Thedisplayswitchestothescreenthat
transmitsthereferencesignal.
3. MovethecursortoOFFandpushtheRTN
button.
4.Onceitscrollstothemodeofyourchoice,
pushtheRTNbutton.
5. Setthetransmitter'sdisplayedspeed.Adjust
thegovernor'sspeeddisplayonitsside.
(Refertoyourgovernor'sinstructionmanual
onhowtomakeproperadjustments).