GAMATRONIC ELECTRONIC INDUSTRIES LTD.
+
SA: 20, 30 and 40 kVA, Release 2.1
139
10.3.7.1 Network configuration
The “Network configuration” option on the Configuration menu is equivalent to navigating to
Setup > Service > SC2012 > Network on the Power+ SA physical control panel. Here you
define the parameters needed to communicate with the Power+ SA over an intranet or over
the Internet. Consult your local network administrator for the proper IP address, subnet
mask, and Gateway address.
Figure 290: Configuring network communication parameters
10.3.7.2 “Date and time” – setting the calendar and clock
The “Date and time” option on the Configuration submenu is used to set the date and time
of the Power+ SA internal calendar and clock. The date and time settings are important, for
they are used to timestamp entries in the Power+ SA log.
The date and time are kept current by the Power+ SA, including when the system is in the
“off” state.
Click the Back button to return to the Configuration menu.
Figure 291: Setting the Power+ SA internal date and time
To Next Page
Loading...
