Gamatronic power+ sa - Figure 132: Set the Integration Factor Alarm

GAMATRONIC ELECTRONIC INDUSTRIES LTD.
POWER
+
SA: 20, 30 and 40 kVA, Release 2.1
81
2. Use the arrow keys to set the integration factor alarm value—press Ent to accept or
Esc to discard:
[Main Menu > SETUP > (password) > ALARM SET > INTEGRAT.]
SET INTEGRATION FACTOR
(1 – 30)
ENTER = ACCEPT 05 ESC = DISCARD
Figure 132: Set the integration factor alarm
Note: The Alarm Integration Factor determines the number of times that the controller polls
and retries to determine the USP status before deciding on an error status. Setting
the alarm integration factor too low will cause spurious alarms to be generated;
conversely, setting the alarm integration factor too high may result in an alarm only
being raised when it is already too late to take corrective action.