GAMATRONIC ELECTRONIC INDUSTRIES LTD.
+
SA: 20, 30 and 40 kVA, Release 2.1
9
3.4 Status indicators
The status indicators show precisely what is running and how the UPS is providing power to
the load.
The diagram below shows the power source and destination routes in use for each of the 3
automated operation modes.
Normal
operation
route
Bypass
operation
route
Battery
operation
route
Figure 5: Status indicators
Table 1: Status indicators
Ac Line Green – Shows that the ac input is present and within range
Alarm Red – Flashes to indicate general alarm condition
Battery Green – Shows that the battery is in discharge mode
Bypass Green – Shows that the load is supplied from the ac input
Inverter Green - Shows that the inverter is supplying power to the load
Bat. Test
Blinking Red – Shows that a battery test is in progress
Steady Red – Battery test failure
UPS On Green – Indicates that the UPS is running
Load Green – Indicates that ac voltage is available at the output
To Next Page
Loading...
