Global Parameters
Global parameters can be set for a specific application or for all applications. If parameters are
set, they are used regardless of the selected preset.
1.
Select the
Global Parameters
tab.
2. Select a specific Probe or select All Probes. If All Probes is selected, all probes will be
affected.
3. Select a specific application or select
All Folders
4. Modify the desired parameters (Display Format, Display Size, M-Mode Gray Map, M-
Mode Spectral Tint, Sweep Speed, PW/CW MAP, PW Invert, RT, Spectral Tint,
Annotation Scale, Mirror Left/Right, Mirror Up/Down, Gray Map, Tint Map, Gently Color)
by selecting from the drop down lists.
11.2.5 4DView Dongle
If an option is active on the US-device, it is possible to program the 4DView dongle to also
enable this option for 4DView. Programming is done automatically when a dongle is connected
to the system.
The Dongle is valid for following options:
•
HD
live
™
•
V-SRI
•
HII
Conditions defined for the programming process:
•
The dongle must be a valid 4DView dongle. A common Service dongle cannot be used.
•
This programming possibility is only available if the option is active on the device.
•
Only 5 4DView dongles can be programmed. If the number of 5 programmed dongles is
exceeded, a message appears on the screen.
11.2.6 Biopsy
For more information see
'Biopsy setup'
on page 5-22.
11.2.7 Measure Setup
Global Parameters
For different application, there are different settings available. This information is summarized
on the table below, and the detailed explanation for each selections can be found under the
table.
1. Select an
Application
and a Preset.
2. Edit the settings as you prefer.
System Setup
11-46
Voluson™ SWIFT / Voluson SWIFT+ Instructions For Use
5831612-100 R
evision 4
To Next Page
Loading...
Need help?
General
