UCM6100 Series User Manual
Version 1.0.18.13
If enabled, the batch added extensions will be added to LDAP Phonebook PBX list;
if disabled, the batch added extensions will be skipped when creating LDAP
Phonebook.
Configure the maximum duration of call-blocking.
Configure the maximum number of calls allowed for each remote IP address.
Configure to enable/disable requiring call token. If set to "Auto", it might lock out
users who depend on backward compatibility when peer authentication credentials
are shared between physical endpoints.
The default setting is "Yes".
Enable SRTP for the call. The default setting is "No".
Select Fax Mode for this user. The default setting is “None”.
• None: Disable Fax.
• Fax Detect: Fax signal from the user/trunk during the call can be detected and
the received Fax will be sent to the Email address configured for this extension.
If no Email address can be found for the user, the Fax will be sent to the default
Email address configured in Fax setting page under Web GUI→Call
Features→Fax/T.38.
This option controls how the extension can be used on devices within different types
of network.
• Allow All
Device in any network can register this extension.
• Local Subnet Only
Only the user in specific subnet can register this extension. Up to three subnet
addresses can be specified.
• A Specific IP Address
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
If enable “All”, users do not need to enter password when making an outbound call.
If enable “Follow Me”, the call can dial out via follow me without password.
Select audio and video codec for the extension. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, iLBC, ADPCM, LPC10, H.264,
H.265, H.263, H.263p and VP8.
To Next Page
Loading...
Need help?
General
