270
Program description - Basic settings
Basic settings
SEL
DSC Output
PPM10
Top LCD Contrast
Pitch min back
–15
0
Bottom LCD Contr.
Basic settings
SEL
DSC Output
PPM10
Top LCD Contrast
Pitch min back
+15
0
Bottom LCD Contr.
Simultaneously tapping the or selection keys
of the right four-way button (CLEAR) will reset the
inverse video fi eld back to “0”.
Display light
This line determines how long the transmitter display’s
backlight illumination is to remain on after switching the
transmitter on or after the last activation of a transmitter
operating element.
Available options are “unlim(ited)”, “30 s”, “60 s”, “120 s”
and “off”.
A simultaneous tap on the or selection keys
of the right four-way button (CLEAR) will reset the
inverse video fi eld to “unlimited”.
Power on/off beep
A power on/off beep for the transmitter can be
switched on (“yes”) and off (“no”) in this line.
A simultaneous tap on the or selection keys
of the right four-way button (CLEAR) will switch this
option shown in inverse video back to “yes”.
Battery type
Basic settings
SEL
0
Bottom LCD Contr.
Battery type
Lith.
Display light unlim.
Power-on beep yes
This line specifi es whether transmitter power is pro-
vided by a four-cell NiMH battery or a single-cell LiPo
battery. As a consequence of this setting, the next line
will offer a suitable voltage range for the “Battery warn-
ing” threshold.
A simultaneous tap on the or selection keys
of the right four-way button (CLEAR) will switch this
option shown in inverse video back to “Lith.”.
Battery warning (threshold)
Basic settings
SEL
Battery type
Lith.
Display light unlim.
Power-on beep yes
Battery warning
3.60V
You can arbitrarily specify the warning threshold for the
display …
Batt. must
be re-
charged!!
… – contingent on the battery type selection in the line
above – in increments of 0.01 volt between 4.50 and
5.50 V (NimH battery) or 3.40 and 4.20 V (LiIo/LiPo
battery). Make sure that you do not enter a value which
is too low, so that you still have suffi cient time to safely
land your model in the event of a battery warning.
A simultaneous tap on the or selection keys
of the right four-way button (CLEAR) will switch the
fi eld shown in inverse video back to its factory setting,
4.70 V (NiMh) or 3.60 V (Lith.).
Power on warning
Basic settings
SEL
Battery type
Lith.
Power-on beep
yes
Battery warning
3.60V
Power on warn.
unlim
In this line you can determine how long the transmit-
ter should wait after the last actuation of an operating
element until the activation of an optical and acoustic
power-on warning …
Power on warning
is active!
… before the transmitter switches off automatically one
minute later.
The values “unlim(ited)”, “30 s” and 1, 5, 10, 20, 30 and
60 minutes are optional selections.
A simultaneous tap on the or selection keys
of the right four-way button (CLEAR) will reset the
inverse video fi eld to “unlimited”.
Touch Sense
Basic settings
SEL
Battery type
Lith.
Battery warning
3.60V
Power on warn.
unlim
Touch Sense
2
In this line you can select the touch sensitivity of the
four-way buttons in a range from 1 to 10. The lower
this number is, the more sensitive the four-way button
will be to taps and vice versa.
A simultaneous tap on the or selection keys
To Next Page
Loading...
Need help?
General
