Safety airbag-29
auto body outer panel.
release wiring harness
auto body outer panel.
releases wring harness.
Mutually connect (short) the other end of release wring harness to avoid the possible incorrect release caused by the static
interference.
d. At the clock spring’s 2# joint, tract the translation wiring harness out of the vehicle with the release wiring harness (Figure 9.2)
e. Close all the windows and doors and wear the guard to reduce the noises.
Caution
The guard should be worn because the glass with cracks is very fragile.
f. Shut off the joint of driver’s side safety airbag release wiring harness somewhere far from the vehicle, and connects the joint
with the accumulator and makes the safety airbag release.
clock spring connector clip
clock spring
srs translation wiring harness
release wiring harness
Caution
Continue the operation after the confirmation of nobody is in or next to the vehicle.
Its gas generator is quite hot after the driver’s side safety airbag’s release, it can be used after its cooling down for more
than 30 minutes.
Contact with the local service station of the Great Wall Auto Stock Corporation if the driver’s side safety airbag module
cannot be released.
g. Abandon the released driver’s side safety airbag module according to the instructions.
To Next Page
Loading...
