Hioki 3153 - Page 108

95
_____________________________________________________________________________________________
6.3 Program Setting State
______________________________________________________________________________________________
Test type: DC
Test-voltage value: 2.0 kV
Upper-limit value: 10 mA
Lower-limit value: OFF
Test time: 3.0 s
Ramp-up time: OFF
Ramp-down time: OFF
Test-voltage value: 500 V
Upper-limit value: 100 MΩ
Lower-limit value: OFF
Test time: 5.0 s
Delay time: 0.5 s
Test-voltage value: 1.5 kV
Upper-limit value: 20 mA
Lower-limit value: OFF
Test time: 60.0 s
Ramp-uptime:5.0s
Ramp-down time: OFF
Test-voltage value: 2.0 kV
Upper-limit value: 10 mA
Lower-limit value: OFF
Test time: 3.0 s
Ramp-up time: OFF
Ramp-down time: OFF
(12) Setting the test conditions in step 3
Set the conditions of the test to be conducted in step 3.
When the test conditions have been set, press the
ENTER
key to finalize the
settings. Press the
STOP
key to exit the program setting state. The unit will
change to the program mode and enter the READY state. File 2 is set as
follows:
File: 2
Scanner: OFF
Step 1. Insulation-resistance test
Step 2. AC-withstand-voltage test (50 Hz)
Step 3. DC-withstand-voltage test