Hioki 3153 - Page 144

131
_____________________________________________________________________________________________
8.1 Saving Preset Values
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
key Switches between the test-voltage value and test frequency
value. (AC-withstand-voltage test)
key Switches between the upper-limit value and lower-limit value.
ON/OFF key
Switches between the test time and ramp timer time.
key Switches between the upper-limit value and lower-limit value.
ON/OFF key
Switches between the test time and delay time.
NOTE
If the preset values are OFF, the information that they are OFF is saved. The value
that is effective when they are switched ON using the
ON/OFF
key in the READY
state is also saved.
(When the preset values are switched ON, the delay time in the insulation-resistance
mode is set to 0.1 s.
)
(3) Selecting a file to save
The new data overwrites the previous data. Look for the saved data to be
deleted, using the
/
keys.
Save screen on the withstand-voltage mode
Save screen on the insulation-resistance mode
(4) Saving and canceling data
When the saved data to be deleted is displayed, press
SHIFT
+ keys. This
deletes the saved data and saves the value set in the READY state.
After the saving the data, the unit reverts to the READY state.
Press the
STOP
key to revert to the READY state without saving the target
data.