Hioki 3153 - Page 179

166
_____________________________________________________________________________________________
10.2 Command Table
______________________________________________________________________________________________
Command Explanation Page
∗ESE
Sets the standard event status enable register. 212
∗ESE?
Queries the standard event status enable register. 213
∗OPC
After all action has been completed during execution, performs an
SRQ request.
213
∗OPC?
Queries whether or not all action has been completed during
execution.
213
∗SRE
Sets the service request enable register. 214
∗SRE?
Queries the service request enable register (SRER). 214
∗STB?
Queries the status byte register. 215
∗WAI
Waits until all execution is fully completed. 215
Command Explanation Page
:ESE0
Sets event status enable register 0. 216
:ESE0? Queries event status enable register 0. 216
:TRANsmit:TERMinator
Sets the data terminator for response messages. 217
:TRANsmit:TERMinator? Queries the data terminator for response messages. 217
Common Commands (GP-IB)
Specific Commands (GP-IB)