Hioki 3153 - Page 182

169
_____________________________________________________________________________________________
10.3 RS-232C Command Reference
______________________________________________________________________________________________
Syntax
∗IDN?
Response
syntax
<data1>,<data2>,<data3>,<data4>
<data1>
Manufacturer's name (HIOKI)
<data2>
Model name (3153)
<data3>
Serial No. (Not used - always zero)
<data4>
Software version (V*.** : version No.)
Function
The response consists of the name of the manufacturer of the unit, the model name, and the
software version.
Example
Queries manufacturer's name, model name, Serial No. (Not used - always zero), and software
version.
Transmission ∗IDN?
Response HIOKI,3153,0,V1.00
Manufacturer's name: HIOKI;
Model name: 3153;
Software version: 1.00
Syntax
∗RST
Function
Performs device initial setting.
Withstand-voltage mode (initial setting)
Test type: AC50 Hz
Test-voltage value: 0.20 kV
Lower-limit value setting: OFF
Upper-limit value: 0.20 mA
Lower-limit value: 0.1 mA
Test time setting: ON
Ramp-up time setting: OFF
Ramp-down time setting: OFF
Test time: 0.3 s
Ramp-up time setting: 0.1 s
Ramp-down time setting: 0.1 s
Optional functions (Initial settings)
Set all functions to zero, except for the FAIL
hold function, START protection function,
interface command "START," and PC
interface.
FAIL hold function and START protection
function: 1
Output-voltage restricting value: 5.0 kV
Insulation-resistance mode (initial setting)
Test type: 50 V
Upper-limit value setting: OFF
Upper-limit value: 9999 M
Ω
Lower-limit value setting: 4000 M
Ω
Test time setting: ON
Delay time setting: OFF
Test time: 0.3 s
Delay time: 0.1 s
Note
The settings of the interface command "START" and the PC interface cannot be reset.
The memory of the set values and program files cannot be reset.
Example
Performs device initial setting.
Transmission ∗RST
∗IDN?
Queries manufacturer's name, model name, and software version.
∗RST
Performs device initial setting.