Hioki 3153 - Page 196

183
_____________________________________________________________________________________________
10.3 RS-232C Command Reference
______________________________________________________________________________________________
Syntax
:MEASure:RESult:WITHstand?
Response
syntax
<data1>,<data2>,<data3>,<data4>,<data5>
<data1>
Measured voltage value (unit: kV)
<data2>
Measured current value (unit: mA)
<data3>
Test time elapsed (unit: s)
<data4>
Determination
<data5>
Types of timers
Determination other than types of timers: NR1/NR2 format
Determination:
PASS
UFAIL
(UPPER FAIL)
LFAIL
(LOWER FAIL)
ULFAIL
(UPPER LOWER FAIL)
OFF
(Others)
(Character data)
Type of timer:
0
(test time),
1
(ramp-up time),
2
(ramp-down time) (NR1)
Function
Queries the results of the preceding test. Returns the determination and valid values at
termination of the preceding test. The test results are updated upon termination of a new test.
Example
Queries the measured value for withstand-voltage tests
Transmission :MEASure:RESult:WITHstand?
Response 1.00,2.00,30.0,PASS,0
Measured voltage value: 1.00 kV; Measured current value: 2.00 mA;
Test time elapsed: 30.0 s; Determination: PASS; Test time: 0
Syntax
:MEASure:WITHstand:VOLTage?
Response
syntax
<data>
<data>
Withstand-voltage test measured voltage value (NR2)
Function
Queries the measured voltage value (unit: kV) for withstand-voltage tests.
Example
Queries the measured voltage value for withstand-voltage tests.
Transmission :MEASure:WITHstand:VOLTage?
Response 1.00
The measured voltage value is 1.00 kV.
Error
The execution of this command in a state other than the TEST state causes an execution error.
:MEASure:RESult:WITHstand?
Queries the withstand-voltage test result.
:MEASure:WITHstand:VOLTa
g
e?
Queries the measured voltage value for withstand-voltage tests.