Hioki 3153 - Page 223

210
_____________________________________________________________________________________________
10.6 GP-IB Command Transfer Methods
______________________________________________________________________________________________
Register Read Write
Status byte register
∗STB?
──
Service request enable register
∗SRE? ∗SRE
Standard event status register
∗ESR?
──
Standard event status enable register
∗ESE? ∗ESE
Event status register 0 :ESR0?
──
Event status enable register 0 :ESE0? :ESE0
(4) Event status enable register 0 (ESER0)
This event status enable register masks the corresponding event status
register.
(5) Summary of commands for writing and reading each of the
registers
(6) Transmission and response formats
The transmission and response formats are the same as those used for RS-
232C. See Section 10.1.3.