Hioki 3153 - Page 3

3.3.5 Setting the Type of Test Voltage 29
3.3.6 Examples of Settings 30
3.4 Starting a Test 34
3.4.1 Executing a Test 34
3.4.2 Screening in "TEST" State 36
3.5 "PASS" or "FAIL" Determination 37
3.5.1 "PASS" State 37
3.5.2 Screening in "PASS" State 38
3.5.3 "FAIL" State 39
3.5.4 Screening in "FAIL" State 41
3.6 Automatic Discharge Function 42
Chapter 4 Insulation Resistance Mode Testing Method 43
4.1 Insulation Resistance Mode Display 44
4.2 Displaying the "READY" State
46
4.2.1 Key-lock Function 47
4.3 "SETTING" State 48
4.3.1 Setting the Test Voltage Value 49
4.3.2 Setting the Lower (Upper) Limit Value 50
4.3.3 Setting the Test Time 52
4.3.4 Setting the Delay Time 53
4.3.5 Examples of Settings 54
4.4 Starting a Test 57
4.4.1 Executing a Test 58
4.4.2 Screening in "TEST" State 59
4.5 "PASS" or "FAIL" Determination 60
4.5.1 "PASS" State 60
4.5.2 Screening in "PASS" State 62
4.5.3 "FAIL" State 63
4.5.4 Screening in "FAIL" State 65
4.6 Automatic Discharge Function 66
Chapter 5 Auto Test Mode Testing Method 67
5.1 Auto Test Mode Display 68
5.2 Displaying the "READY" State
70
5.2.1 Key-lock Function 71
5.3 "SETTING" State 72
5.4 Starting a Test
73
5.4.1 Executing a Test 74
5.4.2 Screening in "TEST" State 75
5.5 PASS or FAIL Determination 76