2 - 172 Conversational Part Programming v546CO WinMax Lathe Conversational Part Programming
• SIZING DIAMETER—defines the diameter of the circle, determining the size
of the polygon.
• STOCK SURFACE—defines cutting the flats on either the Outside or the
Inside of the stock.
• R START—defines the starting distance from the centerline.
• C START (DEG)—defines the angle in degrees to the center of the first flat
edge, measured counterclockwise from the home position.
• CORNER RADIUS—defines the radius of all corners of the polygon.
Figure 2–144. Inscribe and Encompass with Corner Radius
• Z START—defines the location where Plunge Feedrate begins. The feedrate is
set in the Plunge Feed field in the Process tab.
• Z BOTTOM—accesses selections for the bottom of the flat and the location
where the Plunge Feed Rate ends.
Inscribe Encompass
To Next Page
Loading...
