1 - 10 Overview v546CO WinMax Lathe Conversational Part Programming
Edit From the Program Review Screen
Position the cursor on the data block or element you wish to edit, and select the
MULTIPLE BLOCK FUNCTIONS F1 softkey on the Program Review screen to access these
editing features:
Move a Data Block
You can move a data block to a different location within the part program using the CUT
F1 and PASTE F3 softkeys. To cut and paste data blocks to another location in a part
program from the Program Review screen:
1. Select the data block you want to move.
2. Select CUT F1.
3. Highlight the data block that will follow the pasted block.
4. Select PASTE F3. The data block that was cut appears above the highlighted
data block on the Program Review screen.
5. Save the revised program.
Copy a Data Block
You can copy a data block to a different location in the part program using the COPY F2
and PASTE F3 softkeys.
1. Select the data block you want to copy.
2. Select COPY F2.
3. Highlight the data block that will follow the copied block.
4. Select PASTE F3. The data block that was copied from the other program
appears above the highlighted data block on the Program Review screen.
5. Save the revised program.
Copy a Data Block to Another Part Program
You can copy a data block to a different part program using the COPY F2 and PASTE F3
softkeys.
1. Select the data block you want to copy.
2. Select COPY F2.
3. Access the Project Manager screen and Open the second part program.
4. Access the Program Review screen for the second part program.
5. Highlight the data block that will follow the copied block.
6. Select MULTIPLE BLOCK FUNCTIONS F1.
7. Select PASTE F3. The data block that was copied from the other program
appears above the highlighted data block on the Program Review screen.
8. Save the revised program.
To Next Page
Loading...
