WinMax Lathe Conversational Part Programming v546CO Conversational Part Programming 2-67
Radial Milling
From the New Block screen, select LIVE TOOLING F3. From the New Block (Live
Tooling) screen, select RADIAL MILLING F1 to access the Radial Milling softkey menu.
Figure 2–54. Live-Tooling New Block Radial Milling screen
• RADIAL LINES AND ARCS F1—accesses the Radial Mill Contour data block
for programming segments with lines, arcs, and blend arcs. Refer to Radial
Lines and Arcs, on page 2 - 71 for programming details.
• RADIAL CIRCLE F2—accesses the Radial Mill Circle data block. Refer to
Radial Circle, on page 2 - 89 for programming details.
• RADIAL FRAME F3—accesses the Radial Mill Frame data block. Refer to
Radial Frame, on page 2 - 95 for programming details.
• RADIAL SLOT F4—accesses the Radial Slot data block. Refer to Radial Slot,
on page 2 - 102 for programming details.
• RADIAL LETTERING F5—accesses the Radial Lettering data block. Refer to
Radial Lettering, on page 2 - 110 for programming details.
To Next Page
Loading...
