WinMax Lathe Conversational Part Programming v546CO Sample Part Program 3-1
SAMPLE PART PROGRAM
The following part programming steps are explained in this section:
Create a New Part Program.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 3
Enter Part Setup information.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 6
Enter Tool Setup information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 7
Enter programming information for Block #1, Profile Start. . . . . . . . . . . . . . . 3 - 9
Enter programming information for Element #1, Face, in Block #1. . . . . . . . . 3 - 12
Enter programming information for Element #2, Turn, in Block #1. . . . . . . . . 3 - 14
Use Verification Graphics to view drawing of part for Block #1. . . . . . . . . . . . 3 - 16
Enter programming information for Block #2, Profile Start. . . . . . . . . . . . . . . 3 - 17
Enter programming information for Element #1, Turn, in Block #2. . . . . . . . . 3 - 20
Enter programming information for Element #2, Face, in Block #2. . . . . . . . . 3 - 22
Enter programming information for Element #3, Chamfer, in Block #2. . . . . . 3 - 24
Enter programming information for Element #4, Turn, in Block #2. . . . . . . . . 3 - 26
Enter programming information for Element #5, Blend Arc, in Block #2.. . . . . 3 - 28
Enter programming information for Element #6, Face, in Block #2. . . . . . . . . 3 - 30
Enter programming information for Element #7, Chamfer, in Block #2. . . . . . 3 - 31
Enter programming information for Element #8, Turn, in Block #2. . . . . . . . . 3 - 33
Enter programming information for Element #9, Face, in Block #2. . . . . . . . . 3 - 35
Access the Program Review Screen to review Blocks#1 and #2. . . . . . . . . . . 3 - 36
Use Verification Graphics to view drawing of part for Blocks #1 and #2. . . . . . 3 - 37
Use Graphics to check stock length. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 37
Use the Verification Graphics Zoom Feature. . . . . . . . . . . . . . . . . . . . . . . . . 3 - 39
Change the Direction of Turning Moves . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 40
Use Multiple Block Functions to finish the part with Block #3, Profile Start. . . . 3 - 40
Use Verification Graphics to view drawing of part for all Blocks. . . . . . . . . . . . 3 - 43
To Next Page
Loading...
