2 - 162 Conversational Part Programming v546CO WinMax Lathe Conversational Part Programming
This setting also applies when rapid motions are made to position for cutting
depths after the first depth.
Example:
In this example, the Z motion would be:
Geometry Tab
Finishing follows the geometry of the contour defined in the Geometry tab.
Finishing follows the geometry of the contour defined in the Geometry tab. The fields on
the Geometry tab are defined as follows:
• COORDINATES—defines the coordinates as either Rectangular or Polar.
• Rectangular coordinates are used when working from a flat drawing.
• Polar coordinates move around the cylinder as specified.
Surface Clearance = 1.27 mm (0.0500 in)
Z Start = 2.54 mm (0.1000 in)
Peck Depth = 5.08 mm (0.2000 in)
1. Rapid to 3.81 mm (0.15 in)
(Z Start + Surface Clearance)
2. Feed to -2.54 mm (-0.1 in) to machine first pass.
3. Rapid back to 3.81 mm (0.15 in)
(Z Start + Surface Clearance)
4. Rapid to -1.27 mm (-0.05 in) (Depth of Previous pass + Surface Clearance)
5. Feed to -7.62 mm (-0.30 in) to machine second pass.
6. Rapid back to 3.81 mm (0.15 in)
(Z Start + Surface Clearance)
7. Rapid to -6.35 mm (-0.25 in)
(Depth of Previous pass + Surface Clearance)
8. Feed to -12.7 mm (-0.5 in) to machine third pass.
9. Rapid back to 3.81 mm (0.15 in) (Z Start + Surface Clearance)
10.Repeat to final depth.
To Next Page
Loading...
