WinMax Lathe Conversational Part Programming v546CO Conversational Part Programming 2-163
The remaining fields are based on your selection in the Coordinates field (Polar or
Rectangular):
When Polar is selected in the COORDINATES field, these fields appear:
Figure 2–133. Live-Tooling Axial Mill Axial Slot screen Geometry tab: Polar Coordinates
• R START—defines the starting distance from the centerline.
• C START (DEG)—defines the angle of the start point to the end point,
measured counterclockwise from the home position.
• R END—defines the starting distance from the centerline.
• C END (DEG)—defines the length of the slot, in degrees, along the C axis,
measured counterclockwise from the home position.
• SLOT WIDTH—defines the width of the slot.
To Next Page
Loading...
