Hurco winmax - Repeat End Block

WinMax Lathe Conversational Part Programming v546CO Conversational Part Programming 2-203
Repeat End Block
Each Repeat Start block requires a Repeat End block.
To access the Repeat End Block screen from the Program Review screen or from the New
Block screen, select the MISCELLANEOUS  F4 softkey followed by the More F7 softkey.
Select the REPEAT END F2 softkey.
To insert a Repeat End block in an existing part program to follow a Repeat Start block,
select the REPEAT END F2 softkey. The REPEAT END screen appears.
Figure 2–164. Repeat End screen