Hurco winmax - Record of Changes

WinMax Lathe Conversational Part Programming v546CO Record of Changes — I
RECORD OF CHANGES
v546CO, January 2018
Revised by: H. Arle
Approved by: D. Skrzypczak
704-0115-211, May 2015
Revised by: K. Gross
Approved by: D. Skrzypczak
704-0115-210, May 2013
Revised by: K. Gross
Approved by: D. Skrzypczak May 2013
704-0115-209, January 2013
Revised by: K. Gross
Approved by: D. Skrzypczak January 2013
704-0115-208, October 2012
Revised by: K. Gross
Approved by: D. Skrzypczak, K.Van Blaircum October 2012
Changes
v546CO: Updated based on software changes.
Changes
704-0115-211: Updates based on software updates through v09.02.160.08.
Updated Radial and Axial Lettering data blocks.
Changes
704-0115-210: Updates based on software updates through v09.02.34.
Revised Finish Tool Cutting Side default values based on Roughing Direction tables.
Added operation description for the Move Tailstock data block when either Interrupt or
Stop Cycle is pressed.
Changes
704-0115-209: Updates based on software updates through v09.02.11.
Revised order of Tool and Tool Offsets fields on Cutoff Block screen.