Hurco winmax - Page 281

II - Record of Changes v546CO WinMax Lathe Conversational Part Programming
704-0115-207, March 2012
Revised by: K. Gross
Approved by: D. Skrzypczak March 2012
704-0115-206, December 2011
Revised by: K. Gross
Approved by: D. Skrzypczak, J. Mulkey, G.Traicoff, K.Van Blaircum December
2011
704-0115-205, April 2011
Revised by: K. Gross
Approved by: D. Skrzypczak, J. Mulkey, G.Traicoff, K.Van Blaircum April 2011
704-0115-204, June 2010, ECN 16538
Revised by: K. Gross
Approved by: D. Skrzypczak, J. Mulkey, G.Traicoff, K.Van Blaircum
June 2010
Changes
704-0115-208: Updates based on software updates through v09.00.43.
Changes
704-0115-207: Updates based on software updates through v8.1.3.48.
Changes
704-0115-206: Updates based on software updates through v8.1.2.30.
Added Program Coordinates section in Live Tooling data blocks section.
Added Move Tailstock and Transfer data blocks.
Set cross-references between books.
Added ScreenPath condition and paragraph tag.
Changes
• 704-0115-205 Updates based on software updates through v8.1.2.18.
Changes
• 704-0115-204 Updates based on software updates through v8.0.