Hurco winmax - Page 282

WinMax Lathe Conversational Part Programming v546CO Record of Changes -III
704-0115-203, March 2009, ECN 16597
Revised by: K. Gross
Approved by: G.Traicoff, D. Skrzypczak March 2009
704-0115-202, October 2007, ECN 16430
Revised by: K. Gross
Approved by: D. Bobeck, R.Gorgol, R.J.McCammon, D. Skrzypczak, C. Thale
Oct. 2007
704-0115-201, 19 May 2005, ECN 15866
Revised by: K. Gross
Approved by: D. Bobeck, D. Skrzypczak, C. Thale 19 May 2005
Changes
• 704-0115-203 rE Updates based on software updates through v2.02.04. Revised
Radial and Axial screen captures and field definitions to match locations axis
orientation and I Plane field and softkey label. March 2009 ECN 16597.
• 704-0115-203 rD Revised cover. Made minor formatting changes for Help
development. January 2009.
• 704-0115-203 rC Updates based on software updates through v2.02.02. Added
information to front matter about On-screen Help and accessing the On-screen
Help in PDF format, November 2008.
• 704-0115-203 rB Updates based on software updates through v2.02.01, 27 June
2008, ECN 16508.
• 704-0115-203 rA Updates based on software updates through v2.02.00, 19 June
2008, prepared for ECN 16508; Internal release.
Changes
Updates based on v1.1, v1.2, and v2.0 software and the introduction of the Live Tooling
(TMM Series) machine.
Changes
New manual release.